LogCorp Shaft extractor is used to remove the head from the shaft of a golf club. Spring tension does all the work. Pulls head straight off the shaft. Light weight at 0.68 lbs. Vise or mounting set up is not needed. Vise could be used to hold the club but is not necessary. Shaft extractor has been tested on steel and graphite shafts. Tool will pull shaft tip sizes up to .410 in diameter.
- Made of 6061 Anodized Aluminum (Dyed Red)
- Made in the USA.
Operation:
- Tighten the wing nuts evenly.
- Clamp shaft (7/16-inch wrench or crescent wrench needed).
- Place hosel protector, loosen wing nuts.
- Apply heat to the head at housel (use a micro torch or a heat gun).
- Spring tension will break the epoxy bond.
Dimensions: 5 in. x 3.5 in.
Package Includes:
- Extractor
- Rubber Clamp
- Hosel Protector
